Marvel 60CIM-SS-F Guía para resolver problemas descargar pdf (Pagina 18)

FILLER PANEL KIT INSTALLATION INSTRUCTIONS (Optional)

Optional Filler Panel kit includes the following:

quantity. 2 Cabinet Extensions

quantity. 2 Kick plate Extensions

quantity. 6 #10 x .50” sheet metal screws

The following tools are needed:

Phillips screwdriver

Scribe or sharp pointed object

Sharp 1/8” diameter. drill bit and drill.

To install the ﬁller Panel kit:

Hold one cabinet extension to side of unit, keeping the 1/2” diameter holes to the outside. Line up the top and front 1.

of the cabinet extension with the top and front of the unit. Mark the 3 hole locations with the scribe.

Drill the scribed hole locations with the 1/8” diameter drill bit. 2. DRILL ONLY ENOUGH TO GO THROUGH THE

CABINETS OUTER SKIN. Do not drill past this point or you will drill to the inside of the unit.

Reposition the cabinet extension to unit and screw in place with 3 of the sheet metal screws. 3. DO NOT OVER TIGHT-

EN THE SCREWS.

Repeat steps 1 through 3 for the other side of the unit.4.

Remove the screws securing the grille to the bottom of the unit. Slide the kick plate extensions behind the grille 5.

as shown. Replace the screws and tighten.

Figure 19

This Filler Panel Kit will add 3 inches to the width of the

ice maker for installation into an 18 inch wide opening.

Order one of the following part numbers for the color

you require:

P/N 42242831 White Filler Panel Kit

P/N 42242832 Black Filler Panel Kit

P/N 42242833 Stainless Steel Filler Panel Kit

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Sin comentarios

Marvel 60CIM-SS-F Guía para resolver problemas Pagina 18