Marvel 60CIM-SS-F Guía para resolver problemas descargar pdf (Pagina 14)

FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS

Step 6: Drill holes in overlay panel

Remove the hinge adapter bushings from the top and

bottom door hinge adapters. (See Figure 16).Using the

holes in the hinge adapters drill 5/16” (8mm) diameter

clearance holes into the overlay panels 3/4” (20mm)

deep. These will be clearance holes for the top and bot-

tom hinge pins.

Also at this time drill the screw pilot holes (10 required)

for attaching the overlay panel to the door. Select the size

of the hole from Table B. Be careful not to drill the pilot

holes through the overlay panel but only 1/2” (12.7)mm

deep.

Material Type #8 Wood Screw

Hardwood 3/32” (2.4mm) Diameter. Pilot Hole

Softwood 5/64 (2.0mm) Diameter. Pilot Hole

Table B

If your refrigerator has a door lock proceed to Step 7.

If your refrigerator does not have a door lock proceed

to Step 9.

NOTE

Step 7: Mark and drill lock hole.

Locate and mark with a pencil the location of the lock

hole on the overlay panel, this is the hole in the top

corner of the handle side of the door. Remove the clamp

and remove the overlay panel from the door. On the

backside of the panel where you marked the lock location

drill a 13/16” (20.5mm) diameter counter bore 7/16”

(11.0mm) deep into the overlay panel. Drill a 15/32”

(12.0mm) diameter hole through the overlay panel cen-

tered on the counter bore being careful not to splinter the

wood on the face side of the panel. (See Figure 13).

Step 8: Assemble the lock parts

Two (2) lock extensions are supplied with the lock. Use

the longer extension for a 3/4” thick overlay panel and

the shorter one for a 5/8” thick panel. Assemble the lock

extension, cam stop washer, spring washer, and set screw

to the lock as shown in Figure 13 and 14.

Install this assembly into the overlay panel and secure

with the retaining nut using a 15mm socket. Make sure

the key slot in the lock is vertical.

Figure 14

Figure 13

SECTION A-A

SCALE 1 : 1

LOCK

NUT

BRASS EXTENSION

CAM

PHILLIPS SCREW

13/16 COUNTER

BORE 7/16 DEEP

15/32 HOLE

3/4 INCH

WOOD PANEL

SPRING WASHER

INNER

DOOR

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Comentarios a estos manuales

Sin comentarios

Marvel 60CIM-SS-F Guía para resolver problemas Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para No Marvel 60CIM-SS-F