Marvel 6BARM Guía para resolver problemas descargar pdf (Pagina 5)

USING YOUR MicroSentry™ REFRIGERATOR CONTROL

Figure 3

Control

Door Switch

During inial startup, or anyme power is interrupted, there will

be an approximate 5 minute delay before the refrigerator starts.

During this period the controller will be assessing the tempera-

ture in the refrigerator and the display will appear errac, this is

normal. The desired temperature set point can be programmed

during this start up period.

Starng your refrigerator

The refrigerator will begin start up when inially plugged in or

when power resumes aer a power outage. At this me the re-

frigerator will take approximately 5 minutes to begin running as

noted above. If the refrigerator has been turned o during use,

“OFF” will appear on the display. To start the refrigerator from

the “OFF” posion press and hold the ON/OFF buon for three

seconds.

Set temperature

To set temperature set point, press and connue to hold “SET”

buon. Aer one second, set point will be displayed. While

holding “SET” buon use the “WARMER” or “COLDER” buon to

desired set point.

NOTE: Momentarily pressing & releasing “SET” buon will access

informaon menu of control. Refer to appendix A for informaon

on this feature.

Refrigerator operaon

The available temperature range for the 6BARM refrigerator is

39° to 65°F (4° to 18°C).

It may take up to 24 hours for your refrigerator to reach desired

temperature. This will depend on amount of contents loaded

and number of openings and closings of the door.

For best results allow refrigerator to “pull down” to desired set

point before loading. Once contents are loaded, allow at least

48 hours for temperature to stabilize before making any adjust-

ments to the set point.

Alarms

Your MicroSentry™ refrigerator control will monitor refrigerator

funcon and alert you with a series of audible and visual alarms.

• Door Ajar Alarm: If the door has been le

open for over ve (5) minutes, the alarm

will sound in one (1) second intervals. The

display panel will ash “do” and the LED light will be a steady

amber color. This will stop as soon as the door is closed.

• High and Low Temperature Alarm: If your

unit reaches an unacceptable temperature

outside of your set point, the alarm will

sound in one (1) second intervals. The

display panel will ash either “hi” or “Lo”

depending upon the condion and the LED light will be a steady

amber color. “hi” indicates that the temperature is 10° F (5.5°C)

above the set point and “Lo” indicates that the temperature is

10° F (5.5°C) below the set point. The alarm will remain acve

unl the condion is corrected.

NOTE: During inial appliance start-up, the high temperature

alarm may sound unl the interior temperature reaches set

point.

• Temperature Sensor Fault: If the controller

detects that the temperature sensor is

not properly funconing, a temperature

sensor alarm will sound. “E1” will ash on the display, and an

alarm will sound. Please call AGA MARVEL Customer Service or

your dealer if this error code is displayed.

• Condenser Needs Cleaning:

When the refrigerator has reached the

recommended amount of run me to neces-

sitate cleaning the air ow, “cL” will ash on the display as a

reminder. See the “Care and Cleaning” secon for cleaning

instrucons.

To clear the alarm:

1) Press and release the “SET buon four mes.

“cnd” will be displayed on the screen.

2) While “cnd” is displayed, press and hold the “SET” but-

ton. The display will show the number of weeks the

refrigerator has been running.

3) While holding the “SET” buon, press and release the

ON/OFF buon. The number shown on the display will

reset to 0.

4) Release the “SET” key.

Alarm Mute

Press any key to mute the audible poron of an alarm.

NOTE-This acon will only mute the alarm. If the condion that

caused the alarm connues, the alarm code will connue to ash

and will sound for 20 seconds every 60 minutes.

NOTE

1 2 3 4 5 6 7 8 9 10 ... 15 16

Comentarios a estos manuales

Sin comentarios

Marvel 6BARM Guía para resolver problemas Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Enfriadores De Vino Marvel 6BARM