Marvel 60RD Guía para resolver problemas Pagina 6

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 24
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 5
6
INSTALLING THE ANTI-TIP DEVICE
"V" notches
in bracket
"V" notches
in bracket
21
7
8"
(55.6cm)
Side of cabinet line
Figure 7
Front of cabinet line
Rear of cabinet line
Rear Leveling leg
Screw
Step by step instructions for locating the po-
sition of the bracket:
1) Decide where you want to place the drawer refrigerator.
Slide it into place, being careful not to damage the oor,
leaving 1"(2.5cm) of clearance from the rear wall to allow
room for the anti-tip bracket.
2) Raise the rear leveling legs approximately
1
4" (6.4mm) to
allow engagement with the anti-tip bracket. Level the unit
by adjusting all the leveling legs as required. Turning the
leveling leg counterclockwise will raise the unit and clock-
wise will lower the unit.
3) Make sure the refrigerator is in the desired location, then
mark on the oor the rear and side corner of the cabinet
where the anti-tip bracket will be installed. If the installation
does not allow marking the rear corner of the cabinet, then
make temporary lines on the oor marking the front corner
of the cabinet, excluding the door. Slide the refrigerator out
of the way. From the temporary line extend the sidewall line
back 21
7
8 (55.6cm) as shown in Figure 7.
4) Align the anti-tip bracket to the marks on the oor so
the side of the bracket lines up with the side of the cabinet
mark, and the "V" notches on the anti-tip bracket line up
with the end of the 21
7
8" (55.6cm) line (Rear of cabinet
line).
5) Fasten the anti-tip bracket to the oor using the supplied
screw. (See Figure 7).
6) Slide the cabinet back into position, making sure the rear
cabinet leveling leg slides under the anti-tip bracket engag-
ing the slot.
One of the rear cabinet leveling legs must be engaged
under an anti-tip bracket.
If oor mounting of the bracket is not possible call AGA
Marvel service at (800-223-3900) for optional wall mount
bracket part number 42245874. The wall mount bracket
requires 1
7
8"(4.8cm)
behind the rear of the cabinet for mounting.
Vista de pagina 5
1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comentarios a estos manuales

Sin comentarios