
29
Drain Pump Removal Instructions:
1. Unplug the ice machine from the electrical supply and
remove the rear access cover from the ice machine.
(See page 27 for instructions).
2. Unscrew the leveling leg in the back corner until the
end of the threaded portion is ush with the threaded
nut insert in the base. (see Figure 39 ).
3. Unscrew the 3 hose clamps and remove the 3 hoses
from the front of the drain pump. (See Figure 39).
4. Rotate the drain pump and remove from the ice ma-
chine, (See Figure 38). It may be necessary to discon-
nect the ground wire connection in the back ange of
the cabinet. (See Figure 39).
5. Disconnect the ice machine power cord from the drain
pump (See Figure 40).
6. Drain the water in the drain pump’s reservoir by turn-
ing the pump upside down and allowing water to drain
through the pump’s inlet and vent tube ttings.
7. Installation of drain pump is reverse of this procedure.
To Restart the Ice Machine
1. Reconnect or turn on the water supply line.
2. Reconnect drain tubing if removed.
3. Plug in the power cord to a wall outlet and turn the ice
machine on, (refer to page 14 for turning the ice ma-
chine on and off).
4. Check the water inlet, drain lines, and ttings for any
water leaks.
5. Check drain pump (if equipped) operation by pouring
approximately two (2) quarts of water into the ice stor-
age bin. The drain pump should activate and discharge
water (refer to Drain Pump on page 7). Check for
water leaks at all hose connections.
14. Remove the top clamp from the vent tube, for easier
access for the air hose.
15. Apply air pressure (approximately 10 psi) to the end of
the vent tube which will purge the remainder of the
water from the drain pump and the drain line. (See
Figure 37).
16. Reinstall the vent tube and clamp to the back of the ice
machine and remove the winterization plug from the ice
bin and save it for future use.
Figure 37
Vent
tube
Remove
clamp
screw
Drain
line
PREPARING THE ICE MACHINE FOR STORAGE
Rotate drain pump and
remove from back of
ice machine.
Figure 38
Comentarios a estos manuales