Marvel ML15CLG1RS Guía del propietario descargar pdf (Pagina 30)

DRAIN PUMP REMOVAL INSTRUCTIONS

Additional issues to be inspected by the in-

staller upon service replacement:

1. The drain pump must be level.

2. No pinched water lines.

3. No interference with electrical cords or wiring.

4. The drain pump should not set on any obstacles, wir-

ing, etc.

5. Secure all hose clamps leading to and from the drain

pump.

6. Insure that the vent tube height is adequate - 18 inches

minimum.

7. Insure that drain height is adequate - maximum of 8

feet.

8. Insure that drain length is adequate - maximum of 20

feet.

9. Checked for water leaks after installation of the drain

pump.

10. Check for vibrations caused by improper installation.

11. Insure that there is no interference with back access

cover.

12. Insure that the hole grommets are in place at each

location so that any vent or drain tubes do not rub on

any sharp surfaces.

Ice machine

power cord

Figure 47

Rotate drain pump and

remove from back of

ice machine.

Figure 46

6. Rotate the drain pump and remove from the ice ma-

chine, (See Figure 46). It may be necessary to discon-

nect the ground wire connection in the back ange of

the cabinet. (See Figure 42).

7. Disconnect the ice machine power cord from the drain

pump (See Figure 47).

8. Drain the water in the drain pump’s reservoir by turn-

ing the pump upside down and allowing water to drain

through the pump’s inlet and vent tube ttings.

9. Installation of drain pump is reverse of this procedure.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 95 96

Sin comentarios

Marvel ML15CLG1RS Guía del propietario Pagina 30