Marvel 30iM Manual de servicio descargar pdf (Pagina 3)

- 3 -

1.2 Serial Nameplate

The serial nameplate is located on the bottom flange directly above the grille on all

Marvel units. Figure 1.1 gives the information that is provided.

The serial number will need to be given whenever parts are ordered or when inquiring

about the ice maker.

1.3 Before Servicing

h Power to the ice maker must be off before any attempt to service. This can be done by

unplugging the unit or disrupting power to the ice maker receptacle. Verify power is

disconnected to unit.

h If unit has been running, use caution around condenser and copper tubing. These

areas may be very hot.

h Use caution around condenser fins and baseplate edges. These areas can be sharp.

h Refrigerant is under high pressure. Evacuate system before attempting to open

refrigerant system.

h Reasonable care and safe work methods should be practiced when working on the ice

maker. Do not work with energized electrical equipment in wet or damp areas.

h Use an appropriate work area and location when performing repairs. You will find

that it is easier to perform work on the ice maker if set on a raised platform or work

table.

h Wear protective safety glasses when performing any kind of work.

h Any refrigerant, whether CFC, HCFC, or HFC (R-12, R-22, or R-134A) must be

recovered. Federal regulations prohibit the intentional venting or release of

refrigerants during the service repair or disposal of an appliance.

Figure 1.1

1 2 3 4 5 6 7 8 ... 34 35

Sin comentarios

Marvel 30iM Manual de servicio Pagina 3