Marvel 15CM Especificaciones descargar pdf (Pagina 14)

Condenser Air Flow

The condenser underneath the cabinet does not re-

quire frequent cleaning; however, sasfactory cooling de-

pends on adequate venlaon over this heat exchanger.

It is recommended to annually clean the condenser by

vacuuming and brushing. To access the condenser, the

unit must be pulled out from the installaon, and the

lower machine compartment access cover removed.

Disconnect the power cord before cleaning the condenser.

Be sure that nothing obstructs the required air ow openings

in front of the cabinet. At least once or twice a year, brush or

vacuum lint and dirt from the front grille area (see page 4).

Cabinet

The painted cabinet can be washed with either a mild soap and

water and thoroughly rinsed with clear water. NEVER use abra-

sive scouring cleaners.

Interior

Wash interior compartment with mild soap and water. Do NOT

use an abrasive cleaner, solvent, polish cleaner or undiluted

detergent.

Care of Unit

1. Avoid leaning on the door, you may bend the door hinges or

p the unit.

2. Exercise cauon when sweeping, vacuuming or mopping

near the front of the unit. Damage to the grille can occur.

3. Periodically clean the interior of the unit as needed.

4. Periodically check and/or clean the front grille as needed.

CARE AND CLEANING

Defrosng Instrucons 15CM and 25CM

1. Push the rocker switch located in the front grille to the

“OFF” posion.

2. Remove the ice bucket and place a towel in the lower front

area of the ice maker to absorb the defrost water.

3. Aer defrosng is completed replace the ice bucket and

press the rocker switch to the “ON” posion.

Defrosng Instrucons 15CAF

1. Disconnect the power cord and set the temperature control

to the o posion. (See page 8).

2. Remove the contents from the freezer.

3. Place pans of hot water in the freezer if you wish to speed

up defrosng.

4. When defrosng is complete wipe out the interior and

replace the contents.

5. Connect power cord to outlet.

6. Set the temperature control to the desired level.

Do not use an ice pick, knife, or any type of sharp object to

remove the ice. Doing so may puncture the units refrigerant

system and damage it beyond repair. You may speed up defrost-

ing by lling the ice bucket with hot water and placing it back

into posion.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios

Marvel 15CM Especificaciones Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Máquinas productoras de hielo Marvel 15CM